A simple Bus Pirate v3 to AVR adapter. This was made to simplify wiring between the v3 Bus Pirate and an AVR ISP header. Tested with the BB313, and ATTiny4313/85s.
Add a 3 pin header and a jumper to power the target AVR from the Bus Pirate (for normal operation, programming, etc).
Check out the “Other work in this field” section below for other adapters as well (some of them support multiple protocols and programmers).
Make one for yourself
Grab a zip file of the entire repository by clicking here.
The .brd file is in the hardware/revA folder.
From there, you can generate your own Gerber files using Eagle and send them off, or use a service which processes the Eagle board file for you.
See the “Bill of Materials” section for information on parts.
Notes & next revision improvements
The silkscreen is really small in some areas. This will be changed in a future run. If making one for yourself, feel free to change the silkscreen text sizes around, and add a miniature dinosaur.
Bill of Materials
1x: Avrrrinator PCB
These parts are from Mouser:
1x: 151-8033-E - Red jumper for power selection
1x: 517-9612066404AR - 6 pin ISP header
1x: 649-68004-236 - Strip of header (enough for both the 10 pin Bus Pirate header and the 3 pin power select switch)
If you don’t already have the necessary cables, pick these up. Both are needed since one connects to the Bus Pirate, and the other connects to the AVR:
These parts are from Adafruit:
1x: 538-90130-1110 (Mouser) - BP box connector. This hasn’t been tested or soldered in, but it appears to fit comfortably within the layout of the board.